Parallel Jaw Grip 4500 Series for ACSR
KT4500
- Versatile grip hold a wider range of ACSR cable sizes reducing the number of grips needed
- Round serrated jaw holds 0.18 to 0.60-Inch (4.57 to 15.20 mm) diameter cable range
- Spring closes grip on cable to hold the initial position
- Spring‐loaded for easy one‐handed operation
- Made in USA
- Large opening in the handle accommodate a wide variety of hooks on hoists, winches and tackle blocks
- Max Safe Load of 5000-Pound (2268 kg)
This versatile grip holds a wider range of ACSR cable sizes reducing the number of grips needed. Klein Parallel Jaw Grips are lightweight and compact. The round jaw holds 0.18 - 0.60-inch diameter cable with a maximum safe load of 5000 lbs. Features a spring that closes the grip on the cable to maintain the initial position.
Specifications
Type:
Parallel Jaw Grip
Application:
Cable Pulling
Special Features:
Sawtooth Jaw Profile Resists Build-up
Cable Type:
ACSR, AAC, Copper
Cable Diameter:
0.18'' to 0.6'' (4.57 to 15.2 mm)
Hot Latch:
N
Swing Latch:
N
Spring:
Y
Locking Handle:
N
Jaw Type:
Round - Serrated
Jaw Length:
4'' (10.2 cm)
Maximum Safe Load:
5000 lb (2268 kg)
Weight:
3.8 lb (1.7 kg)
UPC:
092644477508
Additional Information
Warnings
- Grips are to be used for temporary installation, not for permanent anchorage.
- When used on/or near energized lines, ground, insulate, or isolate grip before pulling.
- Do not exceed rated capacity.
- Always match proper size and type of grip to application.
- Before each use, clean jaw area and inspect grip for proper operation to avoid slippage.
