Chicago® Grip with Latch 0.37-Inch Cable
1684-5H
- Hot-line grips for steel stranded cable
- Grip may be placed on wire with hot-line stick
- When stick is removed, latch closes automatically to guard against grip accidentally disengaging from wire
- Standard hot-line grips are not supplied with springs or lock-open features
- Made in USA
- Locking handle keeps jaw open while grip is placed on cable with a hot stick
Videos
Images
High-Res JPG
1684-5h_photo.jpg
Designed for use on aluminum, copper, weatherproof coated wire, PVC covered conductors and messenger and guy strand. The Chicago style grip was designed for cable sizes from 0.12-Inch to 1.0-Inch (3.10 to 25.4 mm). Hot-line grips for both bare and insulated conductors. Grip may be placed on wire with hot-line stick. When stick is removed, latch closes automatically to guard against grip accidentally disengaging from wire. Standard hot-line grips are not supplied with springs or lock-open features.
Specifications
Type:
Chicago Grip
Application:
Steel Stranded Cable
Special Features:
May Be Placed on Wire with Hot-Line Stick
Material:
Steel
Cable Type:
Aircraft, EHS, Messenger, Guy Strand
Cable Diameter:
0.218'' to 0.55'' (5.54 to 13.97 mm)
Hot Latch:
Y
Swing Latch:
N
Spring:
N
Locking Handle:
Y
Jaw Type:
Double V
Jaw Length:
5'' (12.7 cm)
Maximum Safe Load:
8000 lb (3629 kg)
Weight:
6.5 lb (2.9 kg)
UPC:
092644471674
Additional Information
Warnings
- Before each use, clean jaw area and inspect grip for proper operation to avoid slippage.
- When used on/near energized lines, ground, insulate, or isolate grip before pulling.
- Do not exceed rated capacity.
- Always match proper size and type of grip to application.
- Grips are to be used for temporary installation, not for permanent anchorage.
