Chicago® Grip for EHS Cable, Curved Jaw
1684-74
- When pulling EHS (extra-high-strength) galvanized-steel cable, the galvanizing has a tendency to coat the jaws of any grip, causing the cable to slip
- To reduce the possibility of slippage and damage to the cable, the jaws of this grip are milled on a curve with a double V contour
- For use on aluminum, copper, weatherproof coated wire, PVC covered conductors and messenger and guy strand
- Locking handle keeps jaw open while grip is placed on cable with a hot stick
- Made in USA
Designed for use on aluminum, copper, weatherproof coated wire, PVC covered conductors and messenger and guy strand. The Chicago style grip was designed for cable sizes from 0.12-Inch to 1.0-Inch (3.10 to 25.4 mm). When pulling EHS (extra-high-strength) galvanized-steel cable, the galvanizing has a tendency to coat the jaws of any grip, causing the cable to slip. Double V contour reduces the possibility of slippage and damage to the cable.
Specifications
Type:
Chicago Grip
Cable Type:
Aircraft, EHS, Messenger, Guy Strand
Cable Diameter:
0.218'' to 0.55'' (5.54 to 13.97 mm)
Hot Latch:
N
Swing Latch:
N
Spring:
Y
Locking Handle:
Y
Jaw Type:
Double V, Milled Curved
Jaw Length:
5'' (12.7 cm)
Maximum Safe Load:
8000 lb (3629 kg)
Weight:
5.6 lb (2.6 kg)
UPC:
092644471728
Warnings
- Before each use, clean jaw area and inspect grip for proper operation to avoid slippage.
- When used on/near energized lines, ground, insulate, or isolate grip before pulling.
- Do not exceed rated capacity.
- Always match proper size and type of grip to application.
- Grips are to be used for temporary installation, not for permanent anchorage.